Balancing data speed and angle accuracy in new antenna systems

Researchers found a way to optimize power to improve angle estimation in true-time-delay arrays.

Researchers studied a tradeoff between angle estimation accuracy and data rates. This study focuses on uplink signals in a true-time-delay (TTD) array.

True-time-delay (TTD) arrays use a frequency-dependent response to encode angle information in the receive signal power spectrum. Angle of arrival (AoA) is a parameter estimate used to solve the initial access problem of beam selection.

The work uses Fisher information (FI) to find the Bayesian Cramer-Rao lower bound (BCRLB). This assumes a raised cosine distributed angle prior.

To maximize the FI under a data rate constraint, the study uses waterfilling power per frequency bin. This method depends on sensing weights.

Compared to a frequency flat signal, the optimized power allocation increases the FI by ≈4.9\approx 4.9 dB. This occurs at a 5% rate loss for a prior width of ±10∘\pm 10^{\circ}.

Numerical simulations show a maximum likelihood (ML) estimator can attain the BCRLB above a signal-to-noise ratio (SNR) threshold. This confirms the FI is attainable.

Key facts

  • Optimized power allocation increases the FI by ≈4.9\approx 4.9 dB with a 5% rate loss.
  • The study uses waterfilling power per frequency bin to maximize FI.
  • A maximum likelihood (ML) estimator can reach the BCRLB above an SNR threshold.

All sections

Edition