How floating wind turbine motion affects power output

Researchers found that the pitching motion of floating turbines can increase or decrease the total power produced by a wind farm.

Turbine pitching motion can change the mean power output of a wind farm. This motion can either increase or decrease the power depending on the operational regions.

The study used Large-eddy simulations (LES) to look at aligned floating wind turbine arrays. These simulations used a moving surface drag (MOSD) at the bottom surface.

The researchers compared a traditional constant coefficient actuator disk model (CCADM) with a proposed power-curve-aware extension of the conventional actuator disk model (PCADM).

An actuator disk model is a way to represent turbines in simulations. The CCADM is valid in principle only during Region 2 operation.

The study used IEA 15MW turbines on a UMaine VolturnUS-S platform. They applied harmonic pitching motion matched to a representative ocean wave frequency.

The CCADM produces unphysical power overshoot when relative velocities exceed rated speed. The PCADM eliminates these unrealistic excursions from the actual turbine operating range.

Key facts

  • In-phase motions produce larger fluctuations at the farm scale due to stronger turbine-turbine correlations.
  • The PCADM eliminates unrealistic power excursions caused by harmonic pitching motion.
  • Turbine pitching motion can increase or decrease mean turbine power output.

All sections

Edition